Cutting Vinyl Lattice Circular Saw

If you don t have a vinyl cutting blade you can use another fine toothed blade.

Cutting vinyl lattice circular saw.

Cutting pvc creates sharp saw shavings vinyl lattice is used for a number of things from arbors fence accents and deck or porch skirts. The best saw blade for cutting vinyl lattice is one that has small straight teeth not teeth that are hooked or otherwise designed to rip and tear such as saw blades designed to cut through. The best tool for cutting plastic lattice is a circular saw with a plastic cutting blade. A second option of blade you can use is a fine toothed blade a blade with small and straight teeth.

I had to replace a couple vinyl lattice sections that w. Mark the area to cut and slowly feed the blade into the siding. Cut through the lattice joint by joint using a circular saw with a vinyl cutting blade. This is the easiest way to cut vinyl lattice that i ve come across and i wanted to share it with you.

Made from the same pvc or polyvinyl chloride as plumbing pipe it is molded to look like woven wood lattice. It comes in a variety of designs but a diagonal weave is among the more traditional choices. Use a power saw such as a circular saw or fine toothed hard saw to cut the panels to size. If necessary walk on the lattice to the side of the lumber opposite the saw and marked line.

Start by cutting your vinyl lattice. To cut the vinyl lattice you will need a circular saw and a cutting blade. Always use cutting blades which are sharp enough. Position the saw so it s right along the pencil line then start making a careful straight cut down the lattice.

It also enables you to cut accurately and effectively. Squeeze the saw s trigger and move the circular saw slowly along the full length of the marked line. This will enable you to cut through the staples in the panels with ease. It is best to attach a carbide tipped wood blade to the power saw for a wooden lattice.

You will find a special type of cutting blade specifically made to cut vinyl lattice. Position the circular saw blade at one end of the lattice sheet lining up the blade with the marked cutting line. These include miter saws chop saws table saws and handheld circular saws. If you use a dull blade it will not provide you a good finished result.

Install a plywood blade backward onto a circular saw. For plastic or solid core vinyl lattice you may want to use a vinyl cutting blade.